6 Sided Hexagonal OD Outside Pipe And Tube Scarfing Tools DET Inserts

Tungsten Carbide 6 sided Hexagonal OD Outside Tube and Pipe Scarfing Tools DET Inserts

What about the Scarfing inserts?

Scarfing inserts must be made of extremely hard materials to handle with the operating temperatures and removal of the metals. The inserts should be of the proper grade (hardness) and coating properties to cut the weld bead as cleanly as possible without chattering or chipping and to maintain a smooth pipe surface while extending the life time of the inserts.

What is tube scarfing?Tube scarfing is the process of removing the excess welding material from longitudinally welded tubes or pipes to get smooth surface. Scarfing can refer to the removal of beads on either the outside diameter or inside diameter of the pipes.

The scarfing process need to be processed immediately after welding, so that the material could be removed relatively easily. Therfore, it’s very important for scarfing tools and the corresponding inserts to be reliable and resist chipping and breaking of the cutting surface or the tool itself.

Model List of OD Scarfing Tools DET Insert

ITEM CODE	φI.C	S	a°	φd	Machining Range (mm)
H-R9.0	25	4.76	18	5.16	9-15
H-R13	25	4.76	18	5.16	15-23
H-R17	25	4.76	18	5.16	23-33
H-R21	25	4.76	18	5.16	28-40
H-R28	25	4.76	18	5.16	38-50
H-R38	25	4.76	18	5.16	48-70
H-R48	25	4.76	18	5.16	60-89

Grade Details of 6 sided OD Scarfing Inserts External Scarfing

Advantages of DET OD Tube Scarfing Tools Inserts

A.TiN + Al2O3 coating to suit for different scarfing applications, whether it is a high speed, high heat application or the run of the mill tube scarfing job.

B. Highest quality cutting edge provides extended tool life and superior surface finish

C.Large selection of scarfing tools meet machining request for wide range of tube diameters

Tips on reducing welding chatter

Welding chatter is the result of not being able to scarf the weld bead properly enough to achieve a good, clean tube.

1. The OD scarfing tool should have a slightly larger radius than the OD of the tube.

2. An “ironing pass” can be used after the scarf stand. This stand “irons” out any imperfections the OD scarfing tool misses.

3. The scarfing tool relief should be set at an angle of at least 11 degrees from the work piece to prevent the OD scarfing tool from dragging on the tube.

Other causes of Weld Chatter

1. Dull, chipped, or worn scarfing tool.

2. Not enough weld bead for the scarfing tool to cut.

3. The OD scarfing tool stand is located too far from the weld box causing the weld bead to cool down and not be cut smoothly.

4. Not enough weld power to forge the weld properly.

5. Incorrect OD scarfing tool radius.

After-sale service:

1. Can be refund if there is a quality problem

2. Technical support will be offered once you need

3. Accepting customer visiting